Shrub
Escallonia rubra
Escallonia
Fast evergreen shrub with glossy leaves and clusters of small crimson-pink flowers; superb as a coastal hedge.
- Full sun, Partial shade
- 2–4.5 m (7–15 ft)
- 2–4.5 m (7–15 ft)
- H4 · Zone 8
- June–September
- Evergreen
Overview
Escallonia, also called redclaws, is a fast-growing evergreen shrub from Chile and Argentina. Small, glossy, slightly sticky leaves cover a dense bush that carries clusters of tubular crimson to pink flowers from early summer into autumn, much visited by bees.
It is hardy to about −10°C (14°F), USDA zones 8–10, and thrives in salt spray and wind, making it a classic seaside hedge. It grows in most soils, including chalk. It dislikes hot, humid inland summers and cold, drying winds.
Clip it after flowering; it regrows well even after hard pruning.
At a Glance
Growing Conditions
Aspect Suitability
- East-facing
- South-facing
- West-facing
Site Tolerance
- Exposed sites
- Wind
- Coastal
- Salt
Soil Tolerance
- Clay
- Chalk
- Sandy
- Loam
- Acid
- Neutral pH
- Alkaline
Foliage
Foliage interest: 12 months of the year
Seasonal Timeline
- Flowering Jun Jul Aug Sep
- Foliage 12 months of the year
- Propagate Jun Aug Nov
How to propagate
Ways to grow more Escallonia: the usual steps for each method.
Softwood cuttings Jun Takes a little care
You'll need: Clean, sharp secateurs or a knife, small pots, gritty compost (half compost, half grit or perlite), a plastic bag, and rooting powder if you have it.
- Early in the morning, cut soft, non-flowering shoot tips about 5 to 10 cm long, and keep them in a plastic bag so they don't wilt.
- Trim each one just below a leaf joint and take off the lower leaves, leaving two or three at the top.
- Dip the cut end in rooting powder if you have some.
- Push them into the edge of a pot of gritty compost so their leaves don't touch, and water them in.
- Cover with a clear bag or put them in a propagator, somewhere bright but out of direct sun.
- How long
- Roots in about 3 to 6 weeks.
- It's worked when
- New growth at the tips, and roots showing through the pot's holes.
- Then
- Pot each one up on its own and grow it on. Keep young plants frost-free through their first winter.
Semi-ripe cuttings Aug Takes a little care
You'll need: Clean, sharp secateurs, small pots, gritty compost, and rooting powder if you have it.
- Choose this year's shoots that are firm at the base but still soft at the tip, and cut pieces 10 to 15 cm long.
- Trim just below a leaf joint and take off the lower leaves; pinch out the soft tip.
- Dip the cut end in rooting powder if you have some.
- Push them into pots of gritty compost, water them in and cover with a clear bag.
- Keep them in a cold frame, greenhouse or bright windowsill out of direct sun.
- How long
- Roots in about 6 to 10 weeks.
- It's worked when
- New leaves, and the cutting resists when you tug it gently.
- Then
- Keep them somewhere cool and frost-free over winter, and pot them up separately in spring.
Hardwood cuttings Nov Easy
You'll need: Secateurs, and a spare corner of soil or a deep pot of gritty compost.
- Once the leaves have fallen, cut pencil-thick stems of this year's growth.
- Cut them into 15 to 25 cm lengths: a sloping cut just above a bud at the top, a straight cut just below a bud at the bottom.
- Push them into a slit in the ground (add some sand to the bottom on heavy soil) or a deep pot, so two-thirds is buried.
- Leave them somewhere sheltered, and water in dry spells.
- How long
- Slow but sure: roots by the following autumn.
- It's worked when
- Leaves in spring, and the cutting holds firm when tugged.
- Then
- Lift them and plant them where they're to grow the following autumn.
Roots easily from cuttings at almost any stage.
Garden Design
Works well in: Cottage, Mediterranean, Wildlife-friendly
A dense, flowering windbreak hedge for coastal gardens.
Companion planting: Hydrangeas, Fuchsias, Grasses
Wildlife Value
- Bees
- Butterflies
- Shelter
- RHS Plants for Pollinators
- Nesting cover for birds